TM 10-4630-207-13&P
0045 00
2. Inner rollers and dampers
a. Place the centering plate (figure 18, item 1) on the inner slide (figure 18, item 2).
b. Secure centering plate in place with bolts (figure 18, item 3) and lockwashers (figure 18,
item 4).
c.
Reach through the rear of the inner slide with the top damper (figure 18, item 5).
d. Using a damper pin (figure 18, item 6), secure the small end into the top hole.
e. Reach through the rear of the inner slide with the lower damper (figure 18, item 7)
f.
Using a damper pin (figure 18, item 6), secure the small end into the bottom hole.
g. Insert cotter pins (figure 18, item 8) into top and bottom damper pins.
h. Insert a spacer tube (figure 18, item 9) into the top slot (figure 18, item 10) of the inner slide.
i.
Reach in from the rear of the inner slide with one of the rear rollers (figure 18, item 11)
(chamfered edge out) and thread it onto the spacer tube (figure 18, item 9).
j.
Next on the spacer tube place the end of the top damper (figure 18, item 5), and then the
other rear roller (chamfered edge out).
k.
Reach in from the rear of the inner slide with one of the rear rollers (figure 18 item 11)
(chamfered edge out) and thread it onto the spacer tube (figure 18, item 9).
l.
Next on the spacer tube place the end of the bottom damper (figure 18, item 7), and finally
the other rear roller (chamfered edge out).
m. Insert the third and final spacer tube (figure 18, item 9) onto the top slot (figure 18, item 10)
of the inner slide.
n. Reach in from the rear of the inner slide with one of the rear rollers (figure 18, item 11)
(chamfered edge out) and thread it onto the spacer tube.
o. Next on the spacer tube place a spacer (figure 18, item 12) then the final roller (chamfered
edge out).
p. Insert push rod block (figure 18, item 13) into inner slide (figure 18, item 2).
q. Carefully insert the inner slide (figure 18, item 2) into the outer case (figure 18, item 14) so
as not to dislodge the spacer tube assemblies.
r.
Insert a rear roller bolt (figure 18, item 15) into the front top spacer tube and loosely secure
the bolt with a castle nut (figure 18, item 16).
s.
Insert a rear roller bolt into the bottom spacer tube and loosely secure the bolt with a castle nut
(figure 18, item 16).
0045 00-15
