TM 10-4630-207-13&P
0030 00
NOTE
If a new drive belt will be installed, perform the tensioning procedure described under
REPLACE in WP 0029 00. If a retained belt will be used, adjust it to -inch deflection
at center.
17. Install retained, or new drive belt (figure 11, item 1) (refer to WP 0029 00 as necessary).
18. Align vacuum pump and engine pulleys (figure 11, item 2) as shown, moving the vacuum pump pulley
adapter (figure 11, item 3) slightly to make adjustments.
19. Install and tighten setscrew (figure 11, item 4) on pulley adapter (figure 11, item 3).
3
1
4
2
Figure 11. Installing Pulley
20. Install the throttle, and drive belt guard as described under REPLACE in WP 0029 00.
END OF WORK PACKAGE
0030 00-8
