TM 10-4320-344-24
4.4.3.3 Installation.
a .
b.
c .
d .
e .
f .
g .
h.
i .
If shims are used, shims
removed.
Apply light coating of
must be equal in thickness to shims which were
grease to shims (4) and install shims on cylinder (2).
Install new O-ring seal, if used, on cylinder (2).
Coat rings on piston (1) and interior surface of cylinder (2) lightly with
o i l .
Ensure ring gaps on piston (1) are spaced equally around piston (1).
Install ring compressor on piston (1).
Slide cylinder (2) down piston (1) until rings on piston (1) are inside
c y l i n d e r ( 2 ) .
Remove ring compressor from piston (1) and remove wood blocks from under
p i s t o n ( 1 ).
Rotate cylinder (2) until cutout side
( 5 ).
Install cylinder (2) on crankcase (3)
c y l i n d e r s ( 6 ).
of cylinder (2) is facing pushrod bores
and align cylinder (2) with adjacent
4-17
