For Model 609-C

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
474

TM 10-4320-344-24 Ensure lifting eye mounting holes on Models 609-c and US636HCCD-1 are clean before installing lifting eyes. Do not over tighten lifting eyes. Failure to observe this caution may result in damage to engine. a. Place pan under engine assembly (Figure 3-15, 1). b. A t t a c h l i f t i n g s l i ng c . Remove two nuts (2), washers (3). d . Remove two bolts (5) and hoist to lifting eyes on top of engine assembly (1). lock washers (3), and mounting bolts (4). Discard lock and lock washers (6). Discard lock washers (6). Do not stand or put arms, legs, or any other part of the body under hoisted load. Failure to observe this could result in Three personnel are required to remove engine. caution may result in damage to engine. personal injury or death. Failure to observe this Ensure all disconnected electrical wires and hoses are clear of engine assembly. e . Using hoist, slowly take up weight of engine assembly (1) and carefully slide engine assembly (1) away from pump assembly to separate pump drive coupling from Do not load. death. engine flywheel. stand or put arms, Failure to observe legs, or any other this warning could part of the body under hoisted result in personal injury or Do not rest engine assembly on oil pan or damage will result. f . Hoist engine assembly (1) from trailer (7) and lower onto blocks or engine stand. s u i t a b l e For Model 609-C, refer to paragraph 3.8.4 and replace engine mount isolators after engine assembly is removed. g . Remove lifting sling and hoist from lifting eyes on top of engine assembly ( 1 ). 3-39

Privacy Statement
Press Release
Contact