TM 10-4320-344-24a .Remove cap (Figure 2-172, 1) and fill master cylinder (2) with brake fluid.b .Loosen bleeder screw (3) on right side wheel cylinder.Periodically check fluid level while bleeding brakes and add brake fluid asrequired.c .d .e .f .g.h .i .j .k.Person no. 1: Pump breakaway lever (4) approximately ten times and hold inthe applied position.Person no. 2: Open bleeder screw (3) after final pressure is applied andcheck brake fluid for air bubbles.Person no. 2: Close bleeder screw (3) when brake fluid stops flowing frombleeder screw (3).Repeat steps c through e until there are no air bubbles in brake fluiddraining from bleeder screw (3).Tighten right side wheel cylinder bleeder screw (3).Repeat steps b through g for left side wheel cylinder bleeder screw (3).Check brake fluid level in master cylinder (2) and refill as required.Pump breakaway lever (4) and check system for leaks.Properly dispose of brake fluid in accordance with standing operatingprocedure.NOTE2-387
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
