TM 10-4320-344-242.23.1 WheelAssemblyReplacement..(Continued)lDo not work on equipment that is not securely stabilized to preventrolling or sliding. Ensure both wheels of equipment have chocks thatare secure.•Place braces or jack stands under frame assembly for support.•Failure to obey these warnings may result in serious personal injury ordeath.a .Set handbrakes and, using trailer jacks, jack trailer so tire (Figure 2-168,1) is not touching ground.b .Remove five studt i r e ( 1 ) .2.23.1.2 Installation.nuts (2), wheel clamps (3), and wheel (4) with mountedInstall wheel clamps with side marked WHEEL next to spoke and side marked RIMnext to rim (flat face of clamps out).a.Place wheel (4) with mounted tire (1) on hub (5) with valve stem (6) facingaway from trailer and secure with five wheel clamps (3) and stud nuts (2).Hand tighten stud nuts (2).b .Tighten stud nuts (2) in an every-other-one sequence to 20 ft-lbs. (27 N•m).Continue tightening around wheel in the same order. Increase torque by10 ft-lbs. (14 N•m) each time until each nut is torqued to 90 ft-lbs.(122 N•m).c .Lower trailer to ground.2-378NOTE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
