2.21.10 Cold Starting Aid Maintenance. Model 609-C.This task covers:2.21.10.1 Removal2.21.10.3 Installation2.21.10.2 RepairINITIALSETUPToolsEquipment Conditions (Continued)General Mechanic’s Automotive ToolCold Start Aid Cable disconnected,Kit, Appendix B, Section III,paragraph 2.16.29.Item 1General Safetv InstructionsRiveter, Blind, Appendix B, Section III,Item 4Do not work on equipment that is notsecurely stabilized to prevent rollingMaterials/Partso r s l i d i n g.Lock Washers (TM 10-4320-303-24P)Flammable contents under pressure.Rivets (TM 10-4320-344-24P)Keep sparks, flame, or excessive heataway. Do not puncture container.Equipment ConditionsDo not work on equipment withoutPumping station shut down, TM 10-4320-344-following standard shop safety10.p r a c t i c e s .2.21.10.1 Removal.a .Open cold starting aid access door (Figure 2-124,1), right side engine accessdoor (2), and left side engine access door (3) on pumping assembly (4).b .Removec .Remover i v e tsd.Removee .Removef .Removetubing assembly (5) and elbow (6) from valve (7).two rivets (8) and cable clamps (9) from tubing assembly (5). Discard(8) .grommet (10) from bulkhead panel (11) and tubing assembly (5).tubing assembly (5) from atomizer (12).atomizer (12) and adapter bushing (13) from engine (14).Flammable contents under pressure. Do not smoke near equipment. Keepsparks, flame, and excessive heat away.Do not puncture container.Failureto obey this warning may result in death or personnel injury.g .Loosen clamp (15) and remove cartridge (16) from valve (7).h.Remove two nuts (17), lock washers (18), and cap screws (19), from valve (7).Discard lock washers (18).i .Remove two nuts (20), bolts (21), and clamp (15).2.21.10.2 Repair.a.Inspect tubing assembly (5), valve (7), cable clamps (9), grommet (10), andcartridge (16) for damage.b.Inspect all mounting hardware for damage.2-284TM 10-3420-344-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business