TM 10-4320-344-24
2.21.10 Cold Starting Aid Maintenance, Model 609-C.
(Continued)
c .
Replace all defective components.
2.21.10.3 Installation.
a .
b .
c .
d.
e .
f .
g .
h.
i .
Position clamp (15) on bulkhead panel (11) and secure with two bolts (21) and
nuts (20).
Position valve (7) on bulkhead panel (11) and secure with two cap screws (19),
new lock washers (18), and nuts (17).
Install cartridge (16) in valve (7) and secure with clamp (15).
Install adapter bushing (13) and atomizer (12) into engine (14).
Install tubing assembly (5) on atomizer (12).
Insert tubing assembly (5) through grommet (10) and bulkhead panel (11).
Install grommet (10) in bulkhead panel (11).
Place tubing assembly (5) in two cable clamps (9) and secure cable clamps (9)
to bulkhead panel (11) with two new rivets (8).
Install elbow (6) in valve (7) and install tubing assembly (5) on elbow (6).
Close left side engine access door (3), right side engine access door (2), and
cold starting aid access door (1) on pumping assembly (4).
2-286