TM 10-4320-344-242.21.5 FuelFilterandBaseAssemblyMaintenance,Models609-CandUS636HCCD-1.This task covers:2.21.5.1 Removal2 .21 . 5 . 3 R e p a ir2.21.5.2 Servicing2.21.5.4 InstallationINITIALSETUPToolsEquipment ConditionsGeneral Mechanic’s AutomotivePumping Station shut down, TM 10-4320-344-Tool Kit, Appendix B, Section III,10.Item 1Fuel Filters drained, TM 10-4320-344-10.Goggles, Appendix B, Section III,Item 2Fuel Line Hoses disconnected and capped,paragraph 2.21.2.Gun, Air Blow, Appendix B, SectionIII, Item 2General Safety InstructionsMaterials/PartsDiesel Fuel, Appendix C, Item 10Oil, Appendix C, Item 15Pan, Appendix C, Item 19Rags, Appendix C, Item 20Lock Washers (TM 10-4320-344-24P)Water Separator Fluid Filter(TM 10-4320-344-24P)Fluid Filter Element(TM 10-4320-344-24P)Do not work on equipment that is notsecurely stabilized to prevent rollingo r s l i d i n g .Diesel fuel is flammable. Keep sparks,cigarettes, and open flame away from fuelsystem components.Do not work on equipment without follow-ing standard shop safety practices.This procedure applies to Model 609-C.The procedure for Model US636HCCD-1 iss i m i l a r.2.21.5.1 Removal.Diesel fuel is flammable. Keep sparks, cigarettes, and open flamesaway from fuel system components while working on engine.Ensure container is used to catch fuel and fuel is disposed ofproperly.Failure to obey these warnings may result in personal injury or death.a.Open access door (Figure 2-116, 1) on pumping assembly (2).b .Place pan under drain hoses (3).c .Remove screw (4), two cable clamps (5), and grommets (6).d .Disconnect two drain hoses (3) from two drain plugs (7) and remove drainp l u g s ( 7 ) f r o m f l u i d f i l t e r s ( 8 ).e .Unscrew and remove two fluid filters (8).f .Remove two nuts (9), lock washers (10), flat washers (11), bolts (12), andf l u i d f i l t e r h e a d ( 1 3 ).Discard lock washers (10).2-271NOTE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
