TM 10-4320-344-242.19 HOOD, REAR PANEL, AND SHIELD ASSEMBLY MAINTENANCE.2.19.1 HoodAssemblyMaintenance,Model609-A.This task covers:2.19.1.1 Removal2.19.1.4 Assembly2.19.1.2 Disassembly2.19.1.5 Installation2 .19 . 1 . 3 R e p a irINITIALSETUPToolsGeneral Mechanic’s AutomotiveTool Kit, Appendix B, Section 111,Item 1Material/PartsLock Washers (TM 10-4320-344-24P)Equipment ConditionsPumping station shut down, TM 10-4320-344-10.Equipment Conditions (Continued)Muffler removed, paragraph 2.13.1.Air Cleaner Assembly removed, paragraph2 .14 .1.General Safety InstructionsDo not work on equipment that is notsecurely stabilized to prevent rolling ors l i d i n g.Do not work on equipment without followingstandard shop safety precautions.2.19.1.1 Removal.a .Open two side panel doors (Figure 2-101, 1).b .Remove sixteen screws (2), flat washers (3), and hood assembly (4) frompumping assembly (5).2.19.1.2 Disassembly.a .Remove two bolts (6), flat washers (7), lock washers (8), hood support (9),and two spacers (10) from hood (11).Discard lock washers (8).b .Remove two nuts (12), lock washers (13), flat washers (14), bolts (15), andtwo side panel support brackets (16) from hood support (9).discard lockwashers (13).c .Remove four screws (17) and two retention clips (18) from two side panelsupport brackets (16).2.19.1.3 Repair.a .Inspect hood support (9), hood (11), and side panel support brackets (16) forcracks, bends, holes, or damage.b .Inspect all mounting hardware for damage.c .Replace all defective components.2.19.1.4 Assembly.a.Position two retention clips (18) on side panel support brackets (16) andsecure with two screws (17).b .Position two side panel support brackets (16) on hood support (9) and securewith two bolts (15), flat washers (14), new lock washers (13), and nuts (12).c .Install two spacers (10) and hood support (9) in hood (11) and secure with twonew lock washers (8), flat washers (7), and bolts (6).2-240
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
