TM 10-4320-344-24
2.16.39 Control Enclosure Assembly Maintenance, Model 609-C.
This task covers:
2.16.39.1 Removal
2.16.39.2 Installation
INITIAL SETUP
Tools
General Mechanic’s Automotive
Tool Kit, ppendix B, Section III,
Item 1
Equipment Conditions
Pumping station shut down, TM 10-4320-
344-10.
Battery disconnected, paragraph 2.15.3.
Control Panel Assembly removed,
paragraph 2.16.4.
Control Panel Assembly Wiring Harness
removed, paragraph 2.16.6.
Pump Suction and Discharge Gauge
removed, paragraph 2.16.7.
Oil Pressure Gauge and Engine
Temperature Gauge removed, paragraph
2 .
1
6 .
1
2.
Tachometer removed, paragraph 2.16.12.
Hourmeter removed, paragraph 2.16.12.
Voltmeter removed, paragraph 2.16.12.
Indicators removed, paragraph 2.16.14.
Main Power Switch removed, paragraph
2 .
1
6 .
1
8.
Equipment Conditions (Continued)
Control Panel Toggle Switches removed,
paragraph 2.16.18.
Rheostats removed, paragraph 2.16.22.
Resistors removed, paragraph 2.16.23.
Control Panel Lights removed, paragraph
2.16.24.
Engine Protection System Module removed,
paragraph 2.16.31.
Pressure Control Module removed, paragraph
2.16.31.
Governor Control Module removed, paragraph
2.16.32.
Suction Gauge and Discharge Gauge Hose
Assemblies removed, paragraph 2.16.35.
Suction and Discharge Pressure Regulator
Hose Assemblies removed, paragraph
2.16.35.
General Safety Instructions
Do not work on equipment that is not
securely stabilized to prevent rolling or
s l i d i n g .
Do not work on equipment without following
standard shop safety precautions.
2.16.39.1 Removal.
Remove control enclosure assembly (Figure 2-97, 1).
2.16.39.2 Installation.
Install control enclosure assembly (1).
2-231
