TM 10-4320-344-242.16.40 Base Weldment Maintenance, Model US636HCCD-1.This task covers:2.16.40.1 Removal2.16.40.3 Installation2.16.40.2 RepairINITIALSETUPToolsEquipmentConditions(Continued)General Mechanic’s AutomotiveControl Panel Assembly removed, paragraphTool Kit, Appendix B, Section III,2.16.5.Item 1General Safety InstructionsEquipment ConditionsDo not work on equipment that is notPumping station shut down, TM 10-4320-344-10.securely stabilized to prevent rolling ors l i d i n g.Battery disconnected, paragraph 2.15.4.Do not work on equipment without followingstandard shop safety precautions.2.16.40.1 Removal.Figure 2-98.Base Weldment Maintenance.a.Remove base weldment (Figure 2-98, 1).b.Remove four grommets (2) from base weldment (1).2.16.40.2 Repair.Inspect grommets (2) for corrosion, cracks, slices, or tears.Replace defective grommets (2).2.16.40.3 Installation.a .Install four grommets (2) on base weldment (1).b .Install base weldment (1).2-233
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
