2.15.4.2 Installation.

Figure 2-40. Battery Box and Cover Maintenance, Model US636HCCD-1.

2.15.5 Battery Cable Asssembly Maintenance, Models 609-A and US636HCCD-1

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
127

TM 10-4320-344-24 2.15.4 Battery Box and Cover Maintenance, Model US636HCCD-1. (Continued) d. e . f . Fumes from battery acid may cause explosion, which could result in personal injury. Keep sparks and open flame away from battery. Battery electrolyte contains sulfuric acid, which can cause severe burns. Wear rubber gloves to avoid burns from battery acid. If electrolyte should contact skin or clothing, rinse immediately with clean water and seek medical attention. Two personnel are required to lift battery. Failure to obey these warnings may result in serious personal i n j u r y. Remove storage battery (8) from battery box (9). Remove four nuts (10), lock washers (11), and two weldment supports (12). Discard lock washers (11). Remove battery box (9) from trailer assembly (13). 2.15.4.2 Installation. a . Position battery box (9) on trailer assembly (13). b. Install two weldment supports (12) through battery box (9) and trailer assembly (13) securing with four new lock washers (11) and nuts (10). Fumes from battery acid may cause explosion, which could result in personal injury. Keep sparks and open flame away from battery. Battery electrolyte contains sulfuric acid, which can cause severe burns. Wear rubber gloves to avoid burns from battery acid. If electrolyte should contact skin or clothing, rinse immediately with clean water and seek medical attention. Two personnel are required to lift battery. Failure to obey these warnings may result in serious personal i n j u r y. c . Install storage battery (8) in battery box (9). Install positive battery cable first. Failure to obey this warning may result in death or personnel injury. d. Place two grommets (7) and battery cable assemblies (6) in battery box (9). Install positive (+) and negative (-) battery cable assemblies (6) and two battery cable terminals (5) on storage battery (8). Remove and discard tags. e . Install cover (4) on battery box (9) and secure with two flat washers (3), new lock washers (2), and nuts (1). 2-116

Privacy Statement
Press Release
Contact