d.e .f .g .••••h.2.5.2.2 Automatic Mode. (Continued)c. Unlock AUTO DEFEAT handle (7) and allow to fully retract.Lock inretracted position.Set MAIN POWER switch (9) to ON.Set THROTTLE SELECT switch (6) to AUTO.If regulation of pressure is desired, set AUTO SELECT switch (5) toPRESSURE.If regulation of engine speed is desired, set AUTO SELECT switch (5) toSPEED.CAUTIONDo not use cold starting aid at temperatures above 32° F (0° C).Do not use cold starting aid more than three times in a row.Wait at least three minutes between starting attempts when using colds t a r t a i d.Failure to obey this caution may result in damage to equipment.If engine is cold, perform the following:(1)(2)(3)(4)(5)Pull COLD START AID knob (4).Push COLD START AID knob (4) in and hold for no more than three secondswhile cranking engine.Pull COLD START knob (4) out.If engine does not start, wait at least three minutes and repeat stepf .If pumping assembly does not start after three attempts, using coldstarting aid, notify unit maintenance.WARNINGTo prevent hearing loss, hearing protection must be worn by personnelstanding within 50 feet of operating pumping assembly.CAUTIONTo prevent damage to starter, allow 3 minutesPush ENGINE switch (2) to START position andseconds or until engine starts.When engine( 2 ) .Engine will run at idle speed (650 rpmbetween start attempts.hold for no more than 30s t a r t s , release ENGINE switchas seen on ENGINE SPEEDi n d i c a t e ; ( 1 1 ) ).If engine fails to start, wait 3 minutes between startattempts.When engine is running,turn AUTO THROTTLE rheostat (3) to desired enginespeed, as indicated on ENGINE SPEED indicator (11), (if SPEED is selected).If PRESSURE is selected,turn AUTO THROTTLE rheostat (3) until desiredwater discharge pressure is indicated on PUMP DISCHARGE PRESSURE gauge (1).TM 10-4320-344-10i .j .2-102
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
