REPLACE/INSPECT BALANCER SHAFT.

TM 10-4320-325-14

6-9. REPLACE/INSPECT BALANCER SHAFT.

This task covers:

a. Removal

b. Inspection

Installation

INITIAL SETUP:

Tools

Equipment

Condition

Tool Kit, General Mechanics (Item 1,

Para

Appendix B, Section III)

Crankcase cover removed

Materials/Parts

Diesel fuel (Item 2, Appendix E, Section II)

Figure 6-16. Removing the Balancer Shaft

REMOVAL Refer to Figure 6-16

a. Check the location of the timing marks on all gears

b. Remove the balancer shaft (1)

INSPECTION

a. Clean balancer shaft with diesel fuel

b. Inspect the balancer shaft for damage or excessrve wear Replace balancer shaft and both bearings if damaged

or worn

c. Check for damaged or worn balancer gear Replace If required

d. Inspect bearings for wear, replace if required