4-7. Assembly and Preparation For Use

CHAPTER 4 UNIT MAINTENANCE INSTRUCTIONS - TM-10-4320-318-14_33

4-10. Preparation of Pump Unit for Shipment.

TM-10-4320-318-14 Centrifugal Pump Unit Water 125 (NSN 4320-01-156-3873) Model No. 2x2 SP/52109 EIC: ZHT Manual
Page Navigation
24

TM 10-4320-318-14 c. Inventory items on or in the pump unit against the Components of End Item and Basic Issue items Lists (Appendix C). d. Report damage or discrepancies in accordance with DA PAM 738-750 for Product Quality Deficiency Report (SF-368). 4-7. Assembly and Preparation For Use. a. Fill engine crankcase with lubricating oil (Item 7, Appendix E). Refer to LO 10-4320-318-12. Do not smoke or use open flame explosion will cause damage to personnel. WARNING in vicinity of the pump unit while fueling. Fire equipment or could result in injury or death or to b. Fill fuel tank with clean diesel fuel oil (Item 6, Appendix E). c. Connect suction and discharge piping. Refer to system manual. Section III. PREPARATION FOR STORAGE AND SHIPMENT 4-8. Administrative Storage. This paragraph contains information on administrative additional information is required, refer to AR 750-1. storage procedures. If a. Storage Length and Readiness. Placement of equipment in administrative storage should be for short periods of time (1 -45 days) when a storage of maintenance efforts exists. Items should be in mission readiness within 24 hours or within the time factors as determined by the directing authority. During the storage period, appropriate maintenance records will be kept. b. Prior to Placing Unit in Storage. Before placing equipment in administrative storage, current maintenance services and Preventive Maintenance Checks and Services (PMCS) should be completed, shortcomings and deficiencies should be corrected, and all Modification Work Orders (MWOs) should be applied. c. Storage Site Selection. Inside storage is preferred for items selected for administrative storage. If inside storage is not available, the sites selected should provide required protection from the elements and allow access for visual inspection when applicable. 4-9. Preparation of Pump Unit for Storage. The following steps describe procedures for storing the pump unit. a. Short-Term Storage (less than 90 days). Perform the following steps: (1) Be sure fuel level in tank is full. (2) Be sure oil level in engine is full. (3) Lubricate (LO 10-4320-318-12). b. Leng-Term Storage (more than 90 davs). Perform the following steps: (1) Perform procedures listed in short-term storage (para. 4-9a). (2) Service engine air intake. 4-2

Privacy Statement
Press Release
Contact