TM 10-4320-318-14
Section III. OPERATOR MAINTENANCE PROCEDURES
PARAGRAPH TITLE
PARAGRAPH
Air Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4
3-4. Introduction. This section contains instructions covering maintenance functions for the operator on the pump
unit Personnel required are listed only if the task requires more than one. After completing maintenance
procedure, perform operational check to be sure that equipment is operating correctly.
3-5. MAINTENANCE OF AIR FILTER
This task covers:
a. Remove
b. Install
INITIAL SETUP
Parts/Materials
Rags, Wiping
(Item 8, Appendix E)
Equipment Conditions
Pump unit is shut down (para. 2-8).
a.
REMOVE (Figure 3-1).
Figure 3-1. Air Filter Element
3-4
