TM 10-4320-318-14
b.
Shutdown. Perform the following:
CAUTION
Do not shut down engine suddenly from full-load running or with decompression lever.
Damage to engine may occur.
(1)
(2)
(3)
(4)
Open side door of noise enclosure.
Move speed control lever down from RUN position (1, Figure 2-5) to the START position (2).
Operate engine at no load for 2 to 3 minutes.
Put speed control lever to STOP position (3).
Close side door of noise enclosure.
Figure 2-5. Speed Control Lever
2-9. Operation of Auxiliary Equipment. Not applicable.
2-10. Preparation for Movement. Perform the following:
a.
Disconnect System. Disconnect pump suction and discharge lines to system. Refer to system manual.
b.
Prepare Pump Unit. Perform the following:
(1) Open pump drain valve and allow pump to drain.
(2) When all water has drained from pump, close drain valve.
(3) Install plastic caps on pump suction and discharge ports.
NOTE
Pump unit is now ready for movement.
2-10
