TM 10-4320-318-14
CHAPTER 2
OPERATING INSTRUCTIONS
PARAGRAPH TITLE
PARAGRAPH
Assembly and Preparation for Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .............2-6
Emergency Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .....2-13
Equipment is Not Ready/Available If Column . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ................2-5
General Description and use of Operator’s Controls and Indicators . . . . . . . . . . . . . . . . . . ................2-1
General Operator Preventive Maintenance Checks and Services (PMCS).............................................................2-3
General Operation Under Unusual Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .....2-12
Initial Adjustments and Daily Checks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ........................2-7
Operating Instructions on Decals and Instruction Plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .....2-11
Operating Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...................2-8
Operation of Auxiliary Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-9
Operator’s Controls and Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ......2-2
PMCS Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .........2-4
Preparation for Movement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .....2-10
Section I. DESCRIPTION AND USE OF OPERATOR’S CONTROLS AND INDICATORS
2-1. General. This section provides a description and use of operator controls and indicators that are used to
operate the pump unit. The operator should become thoroughly familiar with the controls and indicators and with
the proper operating procedures for the pump unit.
NOTE
If equipment fails to operate, refer to troubleshooting procedures in Chapter 3.
2-2. Operator’s Controls and Indicators. Table 2-1 describes controls and indicators located on the pump unit.
2-1
