TM 10-4320-315-24
4-5.
MAINTENANCE OF CYLINDER LINERS - (Cont)
c.
INSTALL. (Figure 4-6)
NOTE
Shims must be at least equal in thickness to shims which were removed.
(1)
Install shims (1) on cylinder (2) that are 0.2 mm more than thickness of shims removed.
(2)
Coat piston, rings, and cylinder lightly with oil.
(3)
Install piston ring gaps around piston at 10, 2, and 4 o'clock positions using wrist pin as 12 o'clock.
(4)
Install two small wood blocks under piston to hold it erect.
(5)
Install ring compressor on piston. Slide cylinder down piston until piston rings are inside cylinder.
(6)
Remove ring compressor and wood blocks.
(7)
Rotate cylinder until cutout side of cylinder is facing pushrod bores.
(8)
Install cylinder on crankcase. Align cylinder with adjacent cylinders.
4-11