TM 10-4320-315-24
3-27. MAINTENANCE OF CRANKSHAFT PULLEY AND DAMPER - (Cont)
Figure 3-26. Crankshaft Pulley and Damper
c.
INSTALL.
(1)
Position pulley (2) on damper (7).
(2)
Install flat washers (6) and pulley mounting screws (5).
(3)
Measure gap between pulley (2) and damper (7). Gap must be 1 in. (25.4 mm) or less.
(4)
Lightly coat damper shaft and front seal with grease.
(5)
Align index hole in pulley shaft with index pin on crankshaft gear. Slide damper (7) into position.
(6)
Lightly coat pulley bolt (3) threads with oil. Install bolt (3) on pulley (2).
(7)
Using retainer (1), hold pulley (2) stationary.
(8)
Turn pulley bolt (3) to the left and tighten. Torque bolt to 30 ftlbs (40 Nm).
(9)
Using angle-of-turn indicator, tighten bolt 210°.
3-59