TM 10-4320-315-243-17. MAINTENANCE OF ENGINE AND PUMP ASSEMBLYThis task covers: a.Removeb.InstallINITIAL SETUP:ToolsGeneralSafetyInstructionsGeneral Mechanics Tool Kit(Item 1, Appendix B)WARNINGLifting Eyes (Item 20, Appendix B)Because of the weight and bulk of the engine andMaterials/Partspump assembly, a minimum of two people arerequired to remove/install this equipment. Failure toLockwashers (TM 10-4320-315-24P)comply with this warning could result in death orLoctite (Item 17, Appendix C)serious injury to personnel and damage to equipment.PersonnelRequiredEquipmentConditionsTwoSlave and battery cables disconnected (para. 2-16).Engine controls, wiring harness, and control paneldisconnected (para. 2-29 and 2-35).Air intake line and air intake boot to turbochargerremoved (para. 2-39).Cooling blower air feed removed (para. 2-42).Fuel lines disconnected (para. 2-38).Fuel gage disconnected (para. 2-19).Air discharge duct removed (para. 3-7).Priming and drain pipes removed (para. 3-8).Roof removed (para. 3-7).Rear panels removed (para. 3-8).Interior brace removed (para. 3-15).NOTEEngine or pump can be disconnected and removed separately.a.REMOVE. (Figure 3-12)(1)Remove pump as follows:(a)Remove bolts (1) that secure the bearing housing (2) of pump (3) to engine flywheel housing (4).(b)Remove nuts (5), lockwashers (6), bolts (7), and flat washers (8) from the two pump mounts (11) andisolators (10).3-28
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
