TM 10-4320-315-24
3-8. MAINTENANCE OF NOISE ENCLOSURE REAR PANELS
This task covers:
a.
Remove
b.
Install
INITIAL SETUP:
Tools
Equipment Conditions
General Mechanics Tool Kit
Tail light assemblies and ground wire disconnected
(Item 1, Appendix B)
(para 2-61).
Roof removed (para. 3-7).
Materials/Parts
Lockwashers (TM 10-4320-315-24P)
a.
REMOVE. (Figure 3-3)
(1)
Remove priming pipe (1).
(2)
Remove drain pipe (2).
(3)
Remove bolts (3) and flat washers (4) at side panels (5).
(4)
Remove bolts (6) and flat washer (7).
(5)
Remove left (8) and right (9) center plates.
(6)
Remove bolts (10) and flat washers (11).
(7)
Remove bolt (12), flat washer (13), drain cap chain (14), and flat washer (15).
(8)
Remove left (16) and right (17) rear panels.
(9)
Remove bolts (18), flat washers (19), lockwashers (20), and nut (21).
(10)
Remove panel mounting bracket (22).
b.
INSTALL.
(1)
Install panel mounting bracket (22). Install flat washers (19), bolts (18), lockwashers (20), and nuts (21).
(2)
Install left (16) and right (17) rear panels with flat washers (11) and bolts (10).
(3)
Secure drain cap chain (14) with flat washers (13 and 15) and bolt (12).
(4)
Install left (8) and right (9) center plates. Secure with flat washers (7) and bolts (6).
(5)
Install flat washers (4) and bolts (3) at side panels (5).
(6)
Install drain pipe (2).
(7)
Install priming pipe (1).
3-11
