3-7. MAINTENANCE OF NOISE ENCLOSURE ROOF

MAINTENANCE OF NOISE ENCLOSURE - (Cont) - TM-10-4320-315-24_147

TM-10-4320-315-24 Pumping Assembly Water 600 GPM Trailer Mounted (NSN 4320-01-31448844) Manual
Page Navigation
142

TM 10-4320-315-24 3-7. MAINTENANCE OF NOISE ENCLOSURE ROOF This task covers: a. Remove b. Install INITIAL SETUP: Tools Equipment Conditions General Mechanics Tool Kit Pumping assembly is shutdown with leveling jacks (Item 1, Appendix B) and tripod jack assembly in the operating position (refer to TM 10-4320-315-10). Materials/Parts Personnel Required Lockwashers (TM 10-4320-315-24P) Four a. REMOVE. (Figure 3-2) (1) Loosen hose clamps (1) and disconnect air discharge hose (2) from air baffle (3) and engine. (2) Remove bolts (4), flat washers (5), and roof (6). (3) Remove bolts (7), nuts (8), lockwashers (9), and brackets (10) from roof (6). b. INSTALL. (1) Install brackets (10) to roof (6) with bolts (7), lockwashers (9), and nut (8). (2) Position roof (6) over noise enclosure panels. Secure with flat washers (5) and bolts (4). (3) Connect air discharge hose (2) to air baffle (3) and engine with clamps (1). 3-9

Privacy Statement
Press Release
Contact