TM 10-4320-315-24CHAPTER 2UNIT MAINTENANCE INSTRUCTIONSPARAGRAPH TITLEPARAGRAPHAdministrative Storage .............................................................................................................................................. 2-8Assembly and Preparation For Use ........................................................................................................................... 2-7Common Tools and Equipment ................................................................................................................................. 2-1General, Service Upon Receipt ................................................................................................................................. 2-4General, Unit Preventive Maintenance Checks and Services (PMCS) ..................................................................... 2-11Introduction, Unit Maintenance Procedures .............................................................................................................. 2-15PMCS Procedures ................................................................................................................................................... 2-13Preparation of Pumping Assembly for Shipment ..................................................................................................... 2-10Preparation of Pumping Assembly for Storage .......................................................................................................... 2-9Repair Parts .............................................................................................................................................................. 2-3Service Upon Receipt of Equipment........................................................................................................................... 2-6Site Requirements...................................................................................................................................................... 2-5Special Tools, TMDE and Support Equipment............................................................................................................ 2-2Unit Preventive Maintenance Checks and Services.................................................................................................. 2-12Unit Troubleshooting Procedures ............................................................................................................................ 2-14Section I. REPAIR PARTS, SPECIAL TOOLS, TMDEAND SUPPORT EQUIPMENT2-1. Common Tools and Equipment. Appendix B, Section III contains the authorized common tools. For authorizedequipment, refer to Modified Table of Organization and Equipment (MTOE) applicable to your unit.2-2. Special Tools, TMDE and Support Equipment. No special tools, TMDE, or support equipment are required forthe repair of the pumping assembly at the unit level of maintenance.2-3. Repair Parts.Repair parts for the pumping assembly are listed and illustrated in the Repair Parts and SpecialTools List (RPSTL) TM 10-4320-315-24P.Section II. SERVICE UPON RECEIPT2-4. General. When new, used or reconditioned equipment is first received, it is the responsibility of the person incharge to determine whether the equipment has been properly prepared for service by the supplying organization and tobe sure it is in condition to perform its function. For this purpose, inspect all assemblies, subassemblies, and accessoriesto be sure they are properly assembled, secure, clean and correctly adjusted and/or lubricated. Check all tools andequipment to be sure every item is present, in good condition, clean and properly mounted or stowed.2-5. Site Requirements. Select a site that provides ample space to maneuver vehicles that may be used to move andposition a pumping assembly. Refer to applicable system manual.2-6. Service Upon Receipt of Equipment.a.Visually inspect the pumping assembly exterior starting at the rear to cover rear, sides, front, top, and bottom.Inspect for loose, missing, or damaged items. Check for signs of corrosion.b.Open both sides of noise enclosure panels and inspect interior for loose, missing or damaged items. Check forwater damage, fungi, mildew, and corrosion.2-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business