TM 10-4320-310-144-22.ADJUST CYLINDER HEAD AND VALVE ASSEMBLY (Continued)c.Check clearance between exhaust rocker and valve stemwith a feeler gauge. Tappet clearance cold should be 0.004inch (0.10 mm). To correct clearance loosen nut (2).d.Adjust screw (3) with screwdriver until feeler gauge can bepulled between rocker and valve stem with very slightresistance after nut (2) has been tightened.e.Repeat steps a. through d. for intake rocker and valvestem if necessary.6Install new gasket (6) on cylinder head.7Install cylinder head cover (5) on new gasket (6).8Install two wave washers (4) and hexagon nuts (3). Tightensecurely.NoteInsure that copper washers are in-stalled on both sides of the pipe clipto prevent oil leaks.9Install pipe clip (2), copper washers (7) and hexagon head screw(1).4-36
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business