Section VI. PREPARATION FOR STORAGE OR SHIPMENT

ADJUST CYLINDER HEAD AND VALVE ASSEMBLY (Continued)

4-25. SHORT TERM STORAGE (30 days or less) (Continued)

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
86

TM 10-4320-310-14 Section VI. PREPARATION FOR STORAGE OR SHIPMENT 4-23. GENERAL This section provides instructions for preparing the centrifugal pump unit for short term and intermediate storage or shipment. 4-24. ADMINISTRATIVE STORAGE Administrative storage shall be in accordance with AR 750-1. NOTE When centrifugal pump unit is taken out of service, take special precautions to protect the interior and exterior of the unit from rust accumulation and corrosion. 4-25. SHORT TERM STORAGE (30 days or less) . Death or serious injury could occur if fuel is not handled carefully. Use in a well-ventilated area away from open flame, arcing equipment, ignition sources, heaters, or excessive heat. Engine must be turned off and cool before refueling. Use proper refueling procedures and equipment to avoid spillage. Do not run engine near open fuel containers. Always store fuel in properly marked containers. DO NOT SMOKE. a. Fill fuel tank with diesel fuel. Connect centrifugal pump unit to a flammable liquid supply. Prime pump and operate the engine for 2 minutes. NOTE Do not drain the fuel system after this run. Remove flammable liquid supply after this run. 4-37

Privacy Statement
Press Release
Contact