4-21. REPLACE/ADJUST THROTTLE CONTROL

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
82

TM 10-4320-310-14 4-21. REPLACE/ADJUST THROTTLE CONTROL This task covers: a. Removal c. Adjustments b. Installation INITIAL SETUP Tools General Safety Instructions Tool Kit, General Mechanics Automotive Engine shut down. (Item 1, Appendix B) REMOVAL: 1 Remove hexagon nuts (1 and 2). Remove throttle linkage assembly (3, 4, 5, 6 and 7). 2 Remove two hexagon jam nuts (8), flat washer (9), wave washer (10), hand lever (11), lever (12) and screw (13). 3 Remove two hexagon socket head screws (14) and four flat washers (15), and remove console (16) with attached stops (17). INSTALLATION: 1 Install hexagon screw (13) through console (16), lever (12), hand lever (11), wave washer (10), flat washer (9) and two hexagon jam nuts (8). Hand tighten the hexagon jam nuts. 2 Install flat washers (15) and console (16), and secure with two hexagon socket head screws (14). Tighten the screws securely. 3 Engage tang on hand lever (11) with notch on lever (12) and tighten two hexagon jam nuts (8). 4 Install throttle linkage assembly (3, 4, 5, 6 and 7) joint ends into lever (12) and lever (18). Secure with hexagon nuts (1 and 2) fully tightened. 4-33

Privacy Statement
Press Release
Contact