INSTALLATION - TM-10-4320-310-14

CLEANING/INSPECTION - TM-10-4320-310-14_157

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
151

TM 10-4320-310-14 6-7. REPLACE CRANKSHAFT (Continued) INSTALLATION: 1 Install circlip (4) into roller bearing outer race (5) and press bearing race into crankcase until it comes to a stop at the circlip. 2 Push roller bearing outer race (3) onto crankshaft (1). 3 Install crankcase end play mounting device on crankshaft. WARNING Handling heated parts can cause severe burns. Use proper equipment to handle heated parts. 4 Heat crankcase (1) to 175°F to 210°F (80°C to 100°C). 5 Push in crankshaft (1) and crankcase end play mounting device until mounting device stops. Allow crankcase to cool. Remove mounting device. 6 Heat ball hub disc (6), ball hub (7) and spacer (8) to 175°F to 210°F (80°C to 100°C). 7 Install spacer (8), ball hub (7) and ball hub disc (6) onto crankshaft. NOTE Balls (9), ball shell (10), and sliding disc (11) are governor components. Refer to paragraph 6-5 for Instructions on Installation of these parts. 6-24

Privacy Statement
Press Release
Contact