INSPECT/REPLACE CYLINDER HEAD AND VALVE ASSEMBLY (Continued)

INSTALLATION/ADJUSTMENT - TM-10-4320-310-14_118

INSPECT/REPLACE CYLINDER HEAD AND VALVE ASSEMBLY (Continued) - TM-10-4320-310-14_120

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
112

TM 10-4320-310-14 5-10. INSPECT/REPLACE CYLINDER HEAD AND VALVE ASSEMBLY (Continued) 7 Install cylinder head (1) on cylinder and new gasket (2). NOTE Add silicone to all mating surfaces of rocker arm assembly. 8 Install rocker shaft (3) with rockers, two air shields, fuel tank bracket and lifting eye. Deepest flat on the rocker shaft must be assembled toward the cylinder or the valves cannot be adjusted. Install deflector (4). 9 Install four washers (5) and four nuts (1) on four studs (2) and tighten nuts equally and crosswise to a torque of 47 foot-pounds (6.5 m-kg). 10 Install injector (para 5-7). 11 The adjustment of decompression adjustment screw is required if the engine compresses when the decompression lever is in position 1. a. Put decompression lever (1) in position 1. b. Crank engine clockwise when facing throttle control lever until compression resistance can be felt. 5-23

Privacy Statement
Press Release
Contact