TM 10-4320-307-24
2-26
PIPING AND VENT ASSEMBLY REPLACE.
This task covers:
a. Cleaning
b. Removal
c. Installation
d. Operational Check
INITIAL SETUP
Tools
Manual References
Tool kit, general mechanic's (Item 1, Appendix B)
TM 10-4320-307-10
Materials/Parts
General Safety Instructions
Dry cleaning solvent (Item 30, Appendix C)
Gaskets
Well ventilated area
CLEANING:
Dry cleaning solvent is potentially dangerous. Avoid repeated and prolonged breathing
of vapors and skin contact with the liquid. Do not use near open flame, arcing
equipment, or other ignition source. Always wear eye protection and protective clothing.
Death or serious Injury could occur if compressed air Is directed against the skin. Do not
use compressed air for cleaning or drying unless the pressure is/has been reduced to 30
psi (2.11 kgcm2) or less. When working with compressed air always use chip guards, eye
protection, and other personal protective equipment.
1.
Remove all oily dirt, grease, and diesel fuel from piping and vent assembly with dry cleaning solvent.
2.
Dry all parts with compressed air.
2-72
