TM 10-4320-307-24
3-30
ACCESSORY DRIVE ASSEMBLY REPAIR/REPLACE (CONT ).
INSTALLATION:
1.
If crankshaft was rotated after accessory drive was
removed, rotate crankshaft until timing mark on
camshaft gear is visible in inspection hole (1) before
installing accessory drive assembly.
2.
Install new gasket (2) on accessory drive assembly
(3).
3.
Put
accessory
drive
shaft
dowel
pin
(4)
at
approximately 11:30 o'clock position when facing
shaft from pulley end.
4.
Install accessory drive assembly (3) in gear housing
accessory drive mounting hole.
5.
Check alignment of camshaft gear and accessory
drive gear timing marks through inspection hole (1)
in gear cover.
NOTE
The accessory drive shaft dowel pin will be
at the 12:00 o'clock position after the
accessory drive is installed.
6.
Install and tighten five accessory drive mounting
capscrews (5) with captive washers (6) to 45 ft-lbs
(60 Nm) torque.
7.
Apply antiseize tape to 3/8-inch inspection hole pipe
plug (7).
8.
Install and tighten plug (7) to 20 ft-lbs (30 Nm)
torque.
3-101
