TM 10-4320-307-24
3-30
ACCESSORY DRIVE ASSEMBLY REPAIR REPLACE (CONT).
CAUTION
If the accessory drive dowel pin has been
incorrectly installed, the dowel pin must
be removed before attempting to remove
the accessory drive to prevent damage to
the accessory drive bushing.
11.
Remove five capscrews (10) with captive washers
(11).
12.
Remove accessory drive housing (12) with gasket
(13).
13.
Clean cylinder block and accessory drive housing
gasket surfaces.
DISASSEMBLY:
1.
Remove capscrew (1) and washer (2) from shaft (3).
Install capscrew into shaft after removing washer.
2.
Remove coupling (4) using coupling puller.
3.
Remove washer (5) and thrust bearing (6).
4.
Remove pulley dowel pin (7) from shaft (3).
5.
Place accessory drive housing (8) on a support and
press shaft (3) out of gear (9).
6.
Remove gear (9) and thrust bearing (10) and bushing
(11).
3-98
