TM 10-4320-307-24
3-29
FUEL PUMP ASSEMBLY SERVICE/TEST/REPLACE/CONT ).
CLEANING/INSPECTION:
1.
Clean gasket surface of fuel pump and accessory drive.
2.
Inspect fuel pump for cracks and evidence of leakage. If further maintenance is required, notify general support
maintenance.
INSTALLATION:
1.
Position fuel pump (1) with new gasket on accessory
drive (2) and secure using four bolts (3), lockwashers
(4), washers (5), and nuts (6).
2.
Install speed sensor (7), fuel supply to injector line
(8), gear pump suction line (9), and fuel drain line
from cylinder head (10).
3.
Connect wires to fuel shutoff valve (11), fuel
pressure sensor (12), and actuator (13). Remove
tags.
4.
Connect battery cables in accordance with paragraph
2--27.
OPERATIONAL CHECK:
Touching exhaust system during test can cause severe burns.
CARBON MONOXIDE (EXHAUST GAS) CAN KILL YOU
Exposure to exhaust gases produces symptoms of headache, dizziness,
loss of muscular control, drowsiness, or coma. Brain damage or death can
result from severe exposure.
Fumes from engine become concentrated with poor ventilation. Operate
engine in a ventilated area only.
While running engine, be alert for fumes. If someone is overcome, expose
to fresh air; keep warm and still; give artificial respiration if needed. Seek
medical attention. Administer oxygen, if available.
GOOD VENTILATION IS THE BEST DEFENSE AGAINST EXHAUST
POISONING.
1.
Start engine in accordance with TM 10-4320-307-10.
2.
Check for signs of fuel leaks.
3-95
