TM 10-4320-307-24
3-21
ALTERNATOR REPAIR (CONT ).
ASSEMBLY:
1.
Press bearing (1) and seals (2) in slip ring end housing (3).
2.
Press in drive end bearing (4) and seal (5) and drive end housing (6).
3.
Position bearing retainer (7) on drive end housing and secure using four screws (8).
4.
Position connector assembly (9) on regulator holder (10) and secure using two screws (11).
5.
Install brush holder adapter (12) and install terminal ends.
6.
Position brush holder adapter (12) in slip ring end housing (3) and secure using two screws (13).
7.
Position cover pate (14) and O-ring (15) on slip ring end housing (3) and secure using four screws (16).
8.
Install regulator holder (10) and rectifier assemblies (17) and secure using washers (18), insulation bushings (19), and
screws (20).
9.
Install output terminals (21) and nuts (22).
10. Install terminals and remove tags.
11. Install stator (23) AC terminals and secure using three locknuts (24) and remove tags.
12. Position voltage regulator (25) and gasket (26) on slip ring end housing (3) and secure using four screws and washers
(27).
13. Install rotor (28) into drive end housing (6).
3-58
