TM 10-4320-307-24
3-22
STARTER MOTOR REPAIR (CONT).
8.
Remove five bolts (25) securing lever housing (23) to field frame (11) and separate lever housing from field frame.
9.
Disassemble field frame (11) as follows:
a.
Remove screw (26) securing connector strap (27) to field frame (11) and remove connector strap.
b.
Remove two screws (28) securing each coil retainer (29) to field frame and remove coil retainers and coils.
c.
Remove two spring pins (30), grommet (31), and O-ring (32) from field frame ('11).
10. Disassemble lever housing (23) as follows:
a.
Remove plug (33) and gasket (34) from lever housing (23).
b.
Remove shaft nut (35).
c.
Remove three screws (36) securing solenoid (37) to lever housing (23) and remove solenoid and drive (38).
d.
Remove retaining ring (39), pivot rod (40), and shift mechanism (41) from lever housing.
e.
Remove seal (42) and bushing (43).
f.
Remove two O-rings (44).
g.
Remove bushings from lever housing (23), commutator end cap (6), and nose housing (21) as required.
3-62
