TM 10-4320-307-24
3-20
ENGINE ASSEMBLY REPLACE (CONT).
7.
Install screw (7) with washer (8) and nut (9) hand tight through each foot of fan end engine mounting bracket (2).
8.
Install four screws (10), washers (11), and nuts (12) hand tight through each speed increaser end engine mounting
bracket (1).
9.
Install aligning screw (13) at each fan end mounting pedestal and three aligning screws (14) at each speed increaser
and mounting pedestal.
NOTE
Screw aligning screws in to distance noted during engine removal procedure.
10. Gradually tighten mounting screws (7, 10) to 123 ft-lbs (167 Nm), torquing alternately.
11. Connect fuel supply and return lines and fittings. Refer to paragraph 3-28.
12. Connect oil drain assembly oil hose. Refer to paragraph 2-55.
13. Fill engine lubricating oil sump. Refer to paragraph 2-36.
14. Install conduit layout to engine. Refer to paragraph 2-31.
3-52
