TM10-4320-226-14SECTION IV. OPERATION UNDER UNUSUAL CONDITIONS2.8UNUSUAL ENVIRONMENTAL /WEATHER.2.8.1ColdStartSystem. Refer to FM 9-207, FM 9-31-70, and FM 31-71 for information on cold weatherrequirements. Perform the following procedures to operate the 350 GPM Pumping Assembly in cold weather.a.Keep fuel tank full at all times to prevent ice crystal formation.b.Do not disturb electrical leads or wiring unless repair is needed.2.8.1.1 On all models except Model 350 PAWN perform the following procedures for cold starting.NOTEOn Model 350 PAWN the cold start system is a fully-automatic engine starting fluidsystem designed to spray a controlled amount of starting fluid into the air intake systemof an engine during and immediately after cranking. Refer to paragraph 2.8.1.2.Do not puncture or mishandle quick start kit container. Container contains ether-basedmixture that is extremely flammable and toxic. It can be harmful or fatal if swallowed.Avoid contact with skin or eyes or breathing fumes.Failure to obey this warning mayresult in injury or death.a.Open cold start reservoir cover (1, figure 2-11) and force servicing can (2) into nipple (3) on reservoir (4) sofluid flows from can into reservoir.b.Remove can when reservoir level reaches “MAXI” line, then close cover.Do not operate the 350 GPM Pumping Assembly without grounding.Do not operate pump before replacing priming port cap.Do not operate equipment in enclosed area unless exhaust gases are piped to outsideand adequate ventilation is provided. Avoid inhalation of exhaust fumes.Failure to obey warnings may result in personnel injury or death.Do not stand within 50 feet of operating equipment without ear protection.Failure toobey this warning may result in hearing loss.Do not operate starter motor for more than 10 seconds, damage to starter can result.c.Pump hand pump (5) immediately when depressing start button (6) on control panel.C h a n g e 2 2 - 27
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
