2.7.2 Preparation for Movement to New Worksite.

SECTION IV. OPERATION UNDER UNUSUAL CONDITIONS - TM-10-4320-226-14_62

TM-10-4320-226-14 Water Pumping Assembly Diesel Engine Driven Wheel Mounted 350 Gallons Per Minute (GPM) 275 Foot Head Models: 350 PAW Manual
Page Navigation
47

TM 10-4320-226-14 d. e. f. g.* h. i. j. 2.7.2 Remove quick release pins (1 and 2, figure 2-9) from tongue and extend tongue extension (3) to full length. Insert quick release pin (1 and 2) and secure tongue. Release pintle (4) and connect pumping assembly to towing vehicle (5). Attach and secure 350 GPM Pumping Assembly to towing vehicle. Remove pins (6 and 7) and push upward on trailer support legs (8) until holes align with mounting holes for pins (6 and 7). Reinstall pins (6 and 7) to secure trailer support legs (8). Do not tow 350 GPM Pumping Assembly more that 20 miles per hour (mph). Failure to obey this caution could result in equipment damage. Tow 350 GPM Pumping Assembly to new location at worksite. Preparation for Movement to New Worksite. Perform the following to move 350 GPM Pumping Assembly to another worksite. a. b. c. d. e. f. If operating, perform shutdown procedures provided in paragraph 2.5.2. Disconnect suction hose (1, figure 2-8) from coupler half (2) and connect quick disconnect plug (3) to coupler half (2). Disconnect discharge hose (4) from coupler half (5) and connect quick disconnect cap (6) to coupler half (5). Attach lifting equipment to 350 GPM Pumping Assembly and lift equipment flatbed trailer. Secure the 350 GPM Pumping Assembly on trailer or vehicle. Transport 350 GPM Pumping Assembly to new worksite location. on 2-26

Privacy Statement
Press Release
Contact