TM 10-4320-226-14This task covers: ServicingINITIALSETUPToolsGeneral Mechanic’s Tool Kit (appendix B,Section III, Item 1)EquipmentConditionsEquipment shut down, refer toparagraph 2.5.1.2 or 2.5.2.2.GeneralSafety InstructionsTo prevent rolling or sliding, do not workon equipment that is not securelystabilized.GeneralSafety Instructions(contiuned)Do not smoke or use open flames aroundfuel.Do not operate equipment in enclosedarea unless exhaust gases are piped tooutside and adequate ventilation isprovided.Do not work on equipment withoutfollowing standard shop safetyprecautions.a.b.c.d.e.f.4-54Figure 4-28.Fuel Filter Maintenance.To prevent rolling or sliding, do not work on equipment that is notsecurely stabilized.Ensure both wheels are secure.Do not smoke or use open flames around fuel.Ensure container is used tocatch fuel and fuel is disposed of properly.Do not operate equipment in enclosed area unless exhaust gasesare piped to outside and adequate ventilation is provided.Avoid inhalation of exhaust fumes.Failure to obey these warnings may result in personal injury or death.Unscrew expendable filter (figure 4-28, 1) and discard.Clean seat (2).Lightly oil rubber seal (3), then screw in new filter (1) until seated.Turn filter (1) a final half turn.Refer to paragraph 4.10.16.4 and bleed fuel system.Refer to paragraph 2.5 and start engine and check fuel filter for leaks.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
