TM 10-4320-226-14
4.10.20 Oil Line Maintenance.
This task covers:
4.10.20.1 Removal
4.10.20.2 Installation
INITIAL SETUP
Tools
General Mechanic’s Tool Kit (appendix B,
Section III, Item 1)
Equipment Conditions (continued)
Fuel feed pump removed
(paragraph 4.10.10.17).
Low oil pressure switch and sending
unit, removed (paragraph 4.10.19) .
General Safety Instructions
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
To prevent rolling or sliding, do not
work on equipment that is not securely
stabilized.
Do not work on equipment without
following standard shop safety
precautions.
Figure 4-30.
Oil Line Maintenance.
4.10.20.1 Removal.
To prevent rolling or
securely stabilized.
warning may result in
a.
Remove banjo bolt (1)
b.
Remove oil line (3).
4.10.20.2 Installation,
a.
Position oil line (3)
sliding, do not work on equipment that is not
Ensure both wheels are secure.
Failure to obey this
serious personal injury.
and washers (2).
between oil and fuel filter housing and injection pump.
b.
Install washers (2) and banjo bolt (1).
4-57
