SPEED INCREASER SERVICE/REPAIR (CONT).
Drain oil while warm.
Use speed increaser oil MIL-L-46167 Grade ARCTIC or MIL-L-2104 Grade 15W-40.
Drain oil as follows:
Place a drain pan under oil drain plug (1) and
loosen fill cap (2).
Remove drain plug (1) and drain oil.
Replace drain plug (1) and tighten.
Fill oil as follows:
Remove oil fill plug (2).
Fill oil sump to full mark on dipstick (3).
Replace oil fill plug and tighten.
Lubricate speed increaser (4) pivots as follows:
Grease speed increaser pivots (5 and 6) with one
to two squirts of #2 lithium base grease.
Grease speed increaser bearings (7) with one to
two squirts of #2 lithium base grease.