TM5-4930-230-3Table 4-2. Organizational Maintenance Troubleshooting — ContinuedMALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONStep 7. Check that cam lever on dispensing valves are opening.Replace defective parts.Step 8. Check for leaks in suction lines. Check for leaking gaskets.Replace defective hose or gasket.Section V. MAINTENANCE PROCEDURES.This section provides maintenance instructions for the electric motor, gas engine, pumpingassembly, and hoses that are applicable to organizational maintenance. Components of the pumpingassembly and hoses consist of all hoses, the engine, electric motor, pump, filter/separator, mans t a t i c d i s c h a r g e r e e l , f u e l d i s p e n s i n g n o z z l e a s s e m b l y , f u e l d i s p e n s i n g r e e l a s s e m b l y , a n d a s s e m b l y .T h e t a n k a n d p u m p u n i t c o n t a i n s n i n e f l e x i b l e r u b b e r h o s e s w i t h q u i c k - d i s c o n n e c t c o u p l i ngmale or female. Refer to figure 1-2 for location. The tanks-to-manifold hoses, one 90 inches (22and one 26-1/2 inches (67.31 cm), connect each tank to the pumping assembly manifold. The t o - p u m p h o s e c o n n e c t s t h e m a n i f o l d t o t h e p u m p i n l e t c o n n e c t i o n . T h e p u m p - t o - f i l t e r / s e p a r aconnects the pump outlet to the inlet of the filter/separator. The filter/separator-to-quick-discoc o n n e c t s t h e f i l t e r / s e p a r a t o r o u t l e t t o t h e q u i c k - d i s c o n n e c t t e e . T w o h o s e s c o n n e c t t h e disconnect tee to the left and right dispensing reels. A dispensing hose is connected to and woeach dispensing reel and has a nozzle connected to the dispensing end.a.Removal.(1) Remove all hoses except dispensing reel hose as follows:(a) Close dispensing valves on tanks by setting cam levers to CLOSE position.4-12
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
