PREPARATION FOR MOVEMENT

Figure 4-1. Tank and Pump Unit Tiedown Installation.

TM-5-4930-230-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (Advanced Industries Model 1800) FSN 4930-070-1181 Manual
Page Navigation
44

TM5-4930-230-13 m. Connect 90-inch (228.6 cm) and 26-1/2-inch (67.31 cm) suction hoses to pumping assembly manifold. Refer to figure 1-2 for location. n. Use tiedown strap assembly to attach a tiedown bracket between each side of truck and tiedown link at top of pumping assembly. o. Repeat steps f thru h with each ratchet. p. Raise the tailgate. 4-5. PREPARATION FOR MOVEMENT a. Short Distance Movement. The tank and pump unit is truck mounted and does not require dismantling for short distance movement. Move the tank and pump unit to the new worksite with the vehicle. b. Long Distance Movement. (1) Provide a suitable container for the tank and pump unit. Refer to TM 38-230-2, Chapter 6 for container fabrication instructions. (2) Provide suitable blocking and tiedowns to prevent the unit from shifting during transport. Section Ill. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) 4-6. GENERAL To ensure that the tank and pump unit is ready for operation at all times, it must be inspected systematically so that defects may be discovered and corrected before they result in serious damage or failure. The necessary preventive maintenance checks and services are listed in table 4-1 and shown on figure 4-2. Defects discovered during operation of the system shall be noted for future correction to be made as soon as operation has ceased. Stop operation immediately if a deficiency is noted during operation, which would damage the equipment if operation were continued. If the equipment fails to operate, troubleshoot with the proper equipment. Report any deficiencies using the proper forms. (See DA Pam 738-750). 4.7. INSPECTION AND SERVICE Refer to table 4-1 for a listing of preventive maintenance checks and services which must be per- formed by organizational maintenance. An explanation of the tabular columns is as follows: a. Item Number. The number appearing in this column indicates the chronological order of the checks and services regardless of interval. This column is used as a source of item numbers for the TM Number column on DA Form 2404, Equipment Inspection and Maintenance Worksheet, in recording results of preventive maintenance checks and services. b. Item to be Inspected. This column contains an entry which identifies the item to be inspected. 4-4

Privacy Statement
Press Release
Contact