Section XIII. INLET ELBOW, OUTLET TEE, AND MANIFOLD

TM-5-4930-228-14 Tank and Pump Unit Liquid Dispensing for Truck Mounting (Highland Industries Model 2000) FSN 4930-877-8678 Manual
Page Navigation
59

Section XIII. INLET ELBOW, OUTLET TEE, AND MANIFOLD 4-37. General tank suction lines. A flow of the product from either T h e p u mp and filter / separator are each or both tanks is conducted to the pump suction equipped with an inlet elbow and outlet tee. They through the manifold outlet and a suction hose. route the product into and out of the pump and 4-38. Inlet Elbow and Outlet Tee filter / separator. The manifold controls the flow of the product to the suction side of the pump. Two a. Removal. Refer to figure 4-25 and remove the inlet elbow and outlet tee. quick-disconnect couplings provide inlets for the Figure 4-25. Inlet elbow and outlet tee, removal. b. Cleaning and Inspection. c. Installation. Refer to figure 4-25 and install (1) Clean and dry all parts thoroughly. the inlet elbow and outlet tee in reverse order of (2) Inspect the inlet tees and outlet elbows for removal. cracks, breaks, and other damage. 4-39. Manifold (3) Inspect for worn or broken gaskets. (4) Replace defective parts. a. Removal. Refer to figure 4-26 and remove the manifold. 4-37

Privacy Statement
Press Release
Contact