TM 5-4320-306-10Section III. OPERATION UNDER USUAL CONDITIONS2-4. ASSEMBLY AND PREPARATION FOR USEa. The pumping assembly comes fully assembled, ready for use after attaching the suction and discharge hoses.b. The operator must know how to perform every operation of which the unit is capable. The followingparagraphs contain instructions on starting and stopping the unit, operation of the pump assembly, and coordinating thebasic motions to perform the specific tasks for which the equipment is designed. Since nearly every job presents adifferent problem, the operator may have to vary given procedures to fit an individual job.2-5. INITIAL ADJUSTMENTS AND DAILY CHECKSa. Loosen studs on control panel cover door. Lift door.b. Position controls as follows:(1) MANUAL THROTTLE CONTROL (1) pushed in.(2) Engine START/STOP switch (2) down at STOP position.c. Perform all category B preventive maintenance checks and services (PMCS) listed in Table 2-2. Report anyproblems to organizational maintenance.d. If pumping assembly has not been operated for one week, perform all category B and W PMCS listed inTable 2-2. Report any problems to organizational maintenance.e. If pumping assembly has not been operated for more than a month, perform all PMCS listed in Table 2-2.Report any problems to organizational maintenance.2-53
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business