TM 5-4320-302-14
6-13. GOVERNOR ASSEMBLY (CONT)
Location/Item
Action
Remarks
ASSEMBLY/REPLACEMENT
10. Needle
Press into cup with larger end of drive shaft
sleeve
sleeve mandrel No. 144730.
11. Outer race
Fill with MIL-G-18709 grease.
12. Balls
Install in outer race. Make sure
that there are 19 balls installed.
13. Inside ring
Complete thrust bearing assembly by installing
inside ring.
14. Washers with
Install same number of washers as were
locating lugs
removed. Make sure that locating lugs point
toward thrust bearing.
6-83
