TM 5-4320-302-146-13. GOVERNOR ASSEMBLY (CONT)Location/ItemAction RemarksINSPECTION7. FlyweightsInspect for damage, excessivewear, rust, or corrosion. Re-place if necessary. Checkthat flyweights fit tightlywhen installed in cutouts indrive shaft guide plate.Replace flyweights if theydo not fit tightly. Refer toparagraph 6-14 for replace-ment of guide plate ifnecessary.8. Needle sleeveInspect for damage or excessive wear. Replace ifnecessary.9. Snap ring,Inspect and replace if damaged or excessively worn.washer, insideInspect the 19 balls that are part of the thrust bear-ring, balls,ing. Each ball should be 0.3150 inch (8.0 mm) diam-outer race,eter. Inspect each ball for wear or out-of-roundand cupcondition. Replace any that are worn or out of round.6-82
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
