TM 5-4320-302-145-18.STARTER MOTOR (CONT)Location/ItemActionRemarksCLEANING/INSPECTION/REPAIRWARNINGDry cleaning solvent is flammable and potentiallydangerous to people and property. Do not use nearopen flame, sparks, excessive heat, or on hot surfaces.Flash point of P-D-680 solvent is 100° to 138°F (38° to59°C). Use solvent in a well-ventilated area, and avoidinhaling fumes. If repeatedly exposed to fumes, seekfresh air and immediate medical help. Avoid prolongedexposure of skin to solvent. Wash exposed skinimmediately and thoroughly.Death or severe injury might result when compressed airis used to blow dirt from skin or clothing. Air enteringbody openings is extremely dangerous. Compressed airused for cleaning shall not exceed 100 psi (690 kPa).Use goggles or face shield for eye protection. Do notdirect airstream against skin.16. StarterClean with P-D-680 solvent and dry with compressedcomponentsair. When cleaning armature, exciter winding, andrelay, use soft cloth wet with solvent. Do not soakthese components in solvent. Dry with soft cloth orcompressed air.17. Brush holder,Clean accumulated dirt, carbon, or other foreigncarbon brushes,material from brush holder, carbon brushes, and otherand brushbrush components with P-D-680 solvent. Dry with softcomponentscloth or low pressure compressed air. Inspect forexcessive wear or damage. Inspect commutator end ofbrushes for dirt, glaze, or other material preventing goodelectrical contact with commutator. Replace glazedbrushes or brush components that are excessively wornor damaged. Replace brushes and leads if leads arefrayed or broken.18. Armature andRemove dirt and carbon from between commutator barscommutatorInspect armature and its commutator for excessivewear, missing bars, or broken solder connections.Replace armature if commutator is excessively worn orhas missing commutator bars. Repair any loose orfrayed solder connections at commutator.5-56
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
