TM 5-4320-300-14
6-8. CYLINDER LINER (CONT)
Location/Item
Action
Remarks
24. Lower bearing
Place lower bearing shell in bearing cap, with
shell in cap
tang on shell in notch in cap. Lubricate bear-
ing shell with clean MIL-L-2104 oil.
CAUTION
Equipment damage may occur if connecting rod bolt turns before torque is
applied to nut. Make sure that bolt head is properly seated on con- necting rod
before tightening nut.
25. Bearing cap
Install bearing cap with bearing shell on con-
and shell
necting rod with identification numbers on cap
and rod adjacent to each other. Torque nuts to
40 to 45 ft lb (54 to 61 N•m).
26. Remaining
Install remaining assemblies as described above.
liner, piston,
and rod
assemblies
6-56
